-GENERAL INFORMATON FOR APPLICATION-
1.DC.Electrolytic capacitors
can be used on DC circuit only. The ploarities to be with "+"and
"-"only.it is indicated on proper position or aside of lead
wire/terminal.
2.Non-polarized capacitors can be used on
both AC and DC circuits.
3.If unclear or unkonwn of polarity
of circuit indication. Non-polarized capacitor was recomm-
ended
to be used.
4.Capacitors should not be used at environ
mental temperature which exceeds the range of sp-
ecified
oerating temperature.
5.Capacitors should be stored in
cold and dry place.
6.Re-aging process with rated
voltage must be taken prior to using ,if it has been long time
stored.
7.Capacitors are not suitable for
operating with sudden charge anddischarge which are
frequently
repeated.
8.Capacitors are not suitable for operating at the
current value which over the allowable ripple
range. If
high ripple is required, please contact us with
detalls.
9.Applied working valtage to capacitor which does
not exceed the rated working voltage of
capacitor.
10.To protect inside construction of capactior,
over pull or excessive force to lead wire/terminal
wave is
not permitted.
11.Soldering irons should be kept away from
the vinyl insulation sleeve of capacitor,to
avoid
the casue made over heat or
break domw to sleeve.
12.Capacitor in dip
soldering process, the soldering temperature should never over 260C for to
sencond of soldering
time.
13.Protection for sleeve, marking and sealing
meterials on capacitor body not to be damaged,
capacitor
body not to be damaged, capacitors should never be washed or cleaned by
halogenous agents or solvents such as trichloroethene,
Xylene or acetone etc.
14.Designed capacitorsquality metts
JIS C-5141W
15.Preparation or after treatment testing for
reliability in according with JIS C-5102
16.
Safe |
Unsafe |
Xylence |
1,1,2,-Trichloro- |
Also please pay attention for adhesive agent which used at sealing rubber surface for mounting. | |||||||||||
|
Copyright 2021 ARKSTAR INTERNATIONAL CO., LTD.